My Report

Advanced Machining and Processes Mock Test 1


Correct Answer: 2 points | Wrong: -1 point
Grades: A* (100% score) | A (80%-99%) | B (60%-80%) | C (40%-60%) | D (0%-40%)
advertisement
 10%

Question 1 of 10

1. Non-Traditional machining can also be called as ________

Question 1 of 10

Question 2 of 10

2. Surface defects that may be occurred during thermal machining are ________

Question 2 of 10

Question 3 of 10

3. If there is an increase in viscosity of slurry, what happens to MRR?

Question 3 of 10

Question 4 of 10

4. Of the following scientists, who discovered magnetostrictor effect?

Question 4 of 10

Question 5 of 10

5. What is the key element of water jet machining for material removal?

Question 5 of 10

Question 6 of 10

6. In abrasive machining __________ are used to form the tool.

Question 6 of 10

Question 7 of 10

7. Shaping and Milling are used to generate which one of the following?

Question 7 of 10

Question 8 of 10

8. What is the velocity of water jet stream in water jet machining?

Question 8 of 10

Question 9 of 10

9. What is the general power rating of the hydraulic pump, used in WJM?

Question 9 of 10

Question 10 of 10

10. What is the value of the amplitude obtained when we use mechanical amplifier?

Question 10 of 10


 

Manish Bhojasia - Founder & CTO at Sanfoundry
Manish Bhojasia, a technology veteran with 20+ years @ Cisco & Wipro, is Founder and CTO at Sanfoundry. He lives in Bangalore, and focuses on development of Linux Kernel, SAN Technologies, Advanced C, Data Structures & Alogrithms. Stay connected with him at LinkedIn.

Subscribe to his free Masterclasses at Youtube & discussions at Telegram SanfoundryClasses.