Engineering Drawing Practice Test 10

1. The commands Donut, Block, Spline, Polygon, and Arc etc belong to which tool bar?

2. The VT is _______

3. What does the letter a indicate in the fillet weld dimensioning?

4. In journal bearings, what is the direction of the load on the shaft axis?

5. When the axis of a solid perpendicular to V.P., __________ should be drawn first.

6. Maximum clearance is the difference between ________ size of the hole and the _________ size of the shaft.

7. In hydrodynamically lubricated bearings what type of lubrication exists between load carrying surface and the journal?

8. Which of the following illustrates the flat single-V butt weld with a flat backing run.

9. From the following table find the function modulus of f(C) to construct a Z-type nomograph, for the function f(A) = \(\frac{f(B)}{f(C)}\). Considering the variable scale length value as 20 cm.

10. Find the bearing which does not come under sliding contact bearing?