My Report

Manufacturing Processes I Mock Test 3


Correct Answer: 2 points | Wrong: -1 point
Grades: A* (100% score) | A (80%-99%) | B (60%-80%) | C (40%-60%) | D (0%-40%)
advertisement
 10%

Question 1 of 10

1. Which of the following have a live centre?

Question 1 of 10

Question 2 of 10

2. Crater wear is predominant in

Question 2 of 10

Question 3 of 10

3. Using the Taylor Equation for tool life and letting n = 0.5 and C = 120, calculate the percentage increase in tool life when the cutting speed is reduced by 50%.

Question 3 of 10

Question 4 of 10

4. Flank wear is due to the abrasive action of hard mis-constituents.

Question 4 of 10

Question 5 of 10

5. Which of the following can be effectively used for holding eccentric job?

Question 5 of 10

Question 6 of 10

6. In metal machining, the zone where the heat is generated due to friction between the moving chip and the tool face is called

Question 6 of 10

Question 7 of 10

7. End of the work piece can be supported by using

Question 7 of 10

Question 8 of 10

8. Which of the following position of tumbler gear lever set will move carriage towards headstock of the lathe?

Question 8 of 10

Question 9 of 10

9. Cutting forces can be measured using a

Question 9 of 10

Question 10 of 10

10. Characteristics of coated cutting tools are:

Question 10 of 10


 

Manish Bhojasia - Founder & CTO at Sanfoundry
Manish Bhojasia, a technology veteran with 20+ years @ Cisco & Wipro, is Founder and CTO at Sanfoundry. He lives in Bangalore, and focuses on development of Linux Kernel, SAN Technologies, Advanced C, Data Structures & Alogrithms. Stay connected with him at LinkedIn.

Subscribe to his free Masterclasses at Youtube & discussions at Telegram SanfoundryClasses.